631 12"x 24"Tansfer Tape

Transfer tape is used for getting your cut and weeded vinyl design off the backing paper and onto your final substrate, keeping it together and even. Once you have cut your design in vinyl, take your X-acto knife and weed away the excess vinyl. Get a sheet of transfer tape and lay it down over the design very lightly, sometimes it is helpful to have 2 people each take a side to avoid it sticking down too quickly or uneven. Take your squeegee and start in the middle of the transfer tape, using up and down strokes with medium pressure, move out to the edges of the design. Once you have it down go over the entire thing with a bit more pressure to make sure the vinyl is held securely to the transfer tape. Start pulling from the edge, and lift the transfer tape and vinyl away from the backing paper until it is completely separate. You are now ready to place the design on your substrate. Once you have it even and ready to apply take your squeegee and repeat the up and down strokes from the middle to the edges again with medium to hard pressure. Once the entire thing is done, pull the transfer tape away from the substrate leaving the vinyl securely in place. Throw away the transfer tape, it will not be used again. Transfer Tape is a great way to ensure an even and successful outcome to any vinyl design, especially lettering!